The multiple heading machines cut the stripes 620 mm. width in paving tiles with the requested measure.
The spindles are assembled on a beam with a linear system with two self-aligning guides, protected by a stainless steel covering, with manual lubrification of the moving pieces.
The beam is assembled on two side bearings sliding on special guides with self-lubrificating roller bearing. All the spindles are indipendent and each one carries a Hp 5,5 motor and a disk with a diameter of mm.350.
This website uses third party cookies | X |
This site uses anonymous technical cookies to ensure navigation and third-party cookies to monitor traffic and to offer additional services such as viewing videos or messaging systems. Without third-party cookies some pages may not work properly. Third-party cookies can track your activity and will only be installed by clicking on the "Accept all cookies" button. You can change your selection at any time by clicking on the "Cookie" link on each page at the bottom left. By clicking on one of the two buttons you declare that you have read the privacy policy and to accept the conditions.
|
|